Craftsman 320.28102 Operator's Manual page 11

[] Donot abusecord or charger.Neverusethecordto carrythecharger. D onotpullthe
charger c ordratherthanthe plugwhendisconnecting f romreceptacle,, Damage'to t he
\ ,
cord or charger could occur and create an electnc shock hazard Replace damaged cords
immediately,
[] Make sure cord is located so that it will not be stepped on, tripped over, come in
contact with sharp edges or moving parts or otherwise subjected to damage or stress.
This will reduce the risk of accidental falls, which could cause injury and damage to the cord,
which could result in electric shock.
[] Keep cord and charger from heat to prevent damage to housing or internal parts.
[] Do not let gasoline, oils, petroleum-based products, etc. come in contact with plastic
parts, They contain chemicals that can damage, weaken or destroy plastic+
[] An extension cord should not be used unless absolutely necessary. Use of improper
extension cord could result in a risk of fire and electric shock. If an extension cord must
be used, make sure:
1+That pins on plug of extension cord are the same number, size and shape as hose of plug on
charger,
2, That extension cord is properly wired and in good electrical condition; and
3, That wire size is large enough for AC ampere rating of charger as specified below:
Cord Length (Feet) 25' 50' 100'
CordSize (AWG) 16 16 16
NOTE: AWG = American Wire Gauge
[] Do not operate charger with a damaged cord or plug, which could cause shorting and
electric shock+ If damaged, have the charger repaired or replaced by an authorized service
technician at Sears Service Center,
[] Do not operate charger if it has received a sharp blow, been dropped or otherwise
damaged in any way. Take it to an authorized service technician at Sears Service Center for
an electrical check to determine if the charger is in good working order
[] Do not disassemble charger. Take it to an authorized service technician at Sears Service
Center when service or repair is required Incorrect reassembly may result in a risk of electric
shock or fire,,
[] Unplug charger from outlet before attempting any maintenance or cleaning to reduce
the risk of electric shock.
[] Disconnect charger from the power supply when not in use. This will reduce the risk of
electric shock or damage to the charger if metal items should fall into the opening., it will also
help prevent damage to the charger during a power surge+
[] Risk of electric shock. Do not touch uninsulated portion of output connector or uninsulated
battery terminal+
[] Save these instructions. Refer to them frequently and use them to instruct others who may
use this tool, If you loan someone this tool, loan them these instructions also to prevent misuse
of the product and possible injury,
11