Loading Paper; Connecting Cables; Selecting The Message Language - Kyocera FS-1350DN Installation Manual

3

Loading Paper

1
Pull the paper cassette all the way out
of the printer.
5
Load paper in the cassette, with the
side to be printed downward.
4

Connecting Cables

1
Connect the printer to the PC or your
network device. Use shielded interface
cables. These cables are sold
separately.
5

Selecting the Message Language

1
Turn the power switch on (|).
Important:
The printer will begin replenishing the toner; this will take approximately
15 minutes.
Refer to the Operation Guide to install the printer driver and to set network parameters.
© 2008 by KYOCERA MITA Corporation All rights reserved. 2-28, 1-Chome, Tamatsukuri, Chuo-ku, Osaka 540-8585, Japan
2
Adjust the paper length guide to fit the
paper size.
Important:
Do not exceed the upper limit
of the cassette. Otherwise, it may cause
paper jams.
Note:
Remove the cap, when using the
network interface.
3
Adjust the paper width guides to fit the
paper size.
6
Insert the paper cassette into the slot in
the printer. Push it straight in as far as
it will go.
2
Connect the power cord to the printer
and the other end into a power outlet.
2
Wait until the message display indicates MSG Language. The default message
language is English.
Important:
MSG Language may not appear according to the destination.
3
To change the language, press [ ] or [ ] repeatedly until the message display
shows the desired language.
4
Press [OK]. The message language will be changed.
4
Fan the paper, then tap it on a level
surface to avoid media jams or skewed
printing.
Printed in China 302H456020 Rev.1.0 2008.9