Advertisement
I.
Before attaching air hose or accessories,
make sure
the OFF/AUTO lever is set to "OFF" and the air
regulator is closed.
2.
Attach hose and accessories.
TOO MUCH AIR PRESSURE
CREATES A HAZ-
ARDOUS
RISK OF BURSTING.
CAREFULLY
FOLLOW
STEPS 3 AND 5 EACH TIME THE
COMPRESSOR
IS USED.
Compressed
air from the outfit may contain water
condensation.
Do not spray unfiltered air at an
item that could be damaged.
Some air operated
tools or devices may require filtered air. Read the
instructions
for the air tool or device.
3,
Check the manufacturer's
maximum pressure
rating for air tools and accessories.
The regulator
outlet pressure must never exceed the maximum
pressure rating. If your compressor
is not supplied
with a regulator with gauge, install one before
using accessories.
4.
Turn the OFF/AUTO lever to "AUTO" and allow
tank pressure to build. Motor will stop when tank
pressure reaches "cut-out"
pressure,
5.
Open the regulator by turning it clockwise.
Adjust
the regulator to the correct pressure setting. Your
compressor
is ready for use.
6.
Always operate me air compressor
in well.
ventilated areas; free of gasoline or other solvent
vapors.
Do not operate the compressor
near the spray area.
When you are finished:
7.
Set the "OFFIAUTO"
lever to "OFF".
8.
Turn the regulator
counterclockwise
and set the
outlet pressure to zero.
9.
Remove the air tool or accessory.
10.
Open the regulator and allow the air to slowly bleed
from the tank.
Close the regulator
when tank
pressure is approximately
20 psi.
11.
Drain water from air tank.
WATER WILL CONDENSE
IN THE AIR TANK.
IF
NOT DRAINED,
WATER WILL CORRODE AND
WEAKEN
THE AIR TANK CAUSING A RISK OF
AIR TANK RUPTURE,
With tank pressure at approximately
20 psi, open the
drain cock or drain valve.
NOTE:
if drain cock valve is plugged, release all air
pressure,
The valve can then be removed.
cleaned, then reinstalled.
12.
After the water has been drained, close drain
cock or drain valve. The air compressor
can
now be stored,
o2os17 Rev.o 3/2/oo
10--
ENG
Advertisement
