Advertisement
Available languages
Available languages
CRAFTSMAN
2
YEAR
FULL
WARRANTY
FOR 2 YEARS from the date of purchase, this product is warranted against any defects in material or workmanship.
Defective product will receive free repair or
free replacement
if repair is unavailable.
For warranty coverage details to obtain repair or replacement,
visit the web site: www.craftsman.com
This warranty
covers ONLY defects
in material and workmanship.
Warranty
coverage
does NOT include:
•
Expendable items that can wear out from normal use within the warranty period, such as line, filters, or spark plugs.
•
Product damage resulting from user attempts at product modification
or repair or caused by product accessories.
•
Repairs necessary because of accident or failure to operate or maintain the product according to all supplied instructions.
•
Preventive maintenance,
or repairs necessary due to improper fuel mixture, contaminated
or stale fuel.
This warranty is void if this product is ever used while providing commercial
services or if rented to another person. This warranty gives you specific legal
rights, and you may also have other rights which vary from state to state.
Sears Brands Management Corporation,
Hoffman Estates, IL 60179
APPLiCATiONS
Muffler
AS a trimmer:
*
Cutting grass and light weeds.
.
Edging
.
Decorative trimming around trees, fences, etc.
Starter
Rope
Other optional accessories
may be used with this unit.
Sparl : Plug
On/Off
Switch
D-Handle
Throttle
Control
Fuel Cap
Choke
Lever
Convertible
TM
Coupler
Shield
Cutting
Use only the instructions
that apply to the
type of shaft and shield that the unit is
equipped with.
1.
Place the cutting attachment
shield onto
the shaft housing. Be sure the guard
mounting bracket slides into the slot on
INSTALL CUTTING ATTACHMENT
SHIELD
Shield
\
Mount
Use the following
instructions
if the cutting
"
'
_--'-
_
[ jDra_et
attachment
shield on the unit is not installed.
2.
3.
Fig. 1
the edge of the cutting shield. Rotate
square
Bolt
I
I Washer
the shield into place, counterclockwise
___I
(Fig. 1). The holes in the guard mounting
bracket and cutting attachment
shield will
line up.
From inside the cutting attachment
shield,
push the square bolt through the hole until
the threaded end protrudes
through the
wing Nat
guard mounting bracket (Fig. 2).
Fig.2
Put the washer on the bolt, then screw the
wing nut onto the bolt and tighten.
INSTALL AND ADJUST THE D-HANDLE
1. Push the D-handle down onto the shaft
housing (Fig. 3). The hex bolt hole in the
handle should be on the left side.
2.
Insert the bolt into the hex hole in the
handle and push through. Place the
washer on the bolt, then screw the wing
nut onto the bolt. Do not tighten until
making the handle adjustment.
Grip
Min. 6 in.
(15.24 cm)
D-Handle
I_Wing
Nut
"Bolt
Fig. 3
3.
Rotate the D-handle to place the grip above the top of the shaft housing.
Place it a minimum of 6 inches (15.24 cm) from the end of the shaft grip.
4.
While holding the unit in the operating position (Fig. 11), move the
D-handle to the location that provides the best grip.
5. Tighten the wing nut until the D-handle is secure.
Advertisement
