Advertisement
6. Loosen the screw holding the bevel scale pointer and
adjust pointer to 0 degrees.
Tighten screw.
Remember, the bevel scale is a convenient guide, but
should not be relied upon for precision.
Reassemble the blade support and hold down.
Make trial cuts in scrap wood to determine if your
angle settings are correct.
Adjust the table as re-
quired.
BEVEL
SCALE
POINTER
SCREW
mounting
the scroll saw to a bench
Your scroll saw must be bolted securely to stand or work
bench. In addition, ifthere is any tendency for the scroll
saw to move during certain operation, bolt your scroll
saw stand or workbench to the floor.
SCROLL
SAW
BASE
1. Hardware to mount this saw to a workbench is NOT
supplied with the saw, However, we recommend the
hardware used be no smaller than the following.
Qu antity
Description
4
4
8
Hex Head Screws, 1/4-20 x Length
as required
Flat Washers, 9/32" I,D,
Lockwashers, 9/32" 1.D.
Hex Nuts, 1/4-20
2. A soft foam pad to place between your scroll saw and
workbench is NOT supplied with the saw. However,
we highly recommend the use of such a pad to reduce
noise and vibration.
Quantity
Description
1/2" FOAM
PAD
(OPTIONAL)
|-I
i !
l_
WORKBENCH
t
|
_jHAkE
FLATWASHER
OCKWASHER
X NUT
M NUT
HEX
HEAD
SCREW
Soft foam pad such as carpet padding,
24" x 12" x 1/2"
Do NOT overtighten mounting bolts - leave some cush-
ion in the foam pad for absorbing noise and vibration.
Advertisement
