Advertisement
contents
-.,
Warranty
information ..... ;: .......:.._ ....... :........ .i," ,"_12
General Safety Instructions for Power Tools ...... ..2
Additlonal Safety Instruction for Scrol| Saws ....... 3
Electrical Information ...,..,..,..,
........... ;.i...... .......... 4
Glossary of Terms for Woodworking .... . ..... ...... ...5
Unpacking & Checking Contents ;........... .i............. 6
Assembly
.
o
.
,
.
:
Setting the Table for Horizontal or
Bevel Cutting _ ..................... _,..,.. . ................... 7
Aligning the Bevel Indicator ........................
8
Mountlr_g the Scroll Saw .................................... ....9
Removing and Installing Blades ........................... 10
Recommended
Accessories ................................. 16
Troubleshooting
.....................................................
17
Wiring Diagram .......................................................
17
Repair Parts ............................................................
18
Service lnformaUon ................................................
20
" 4
unpack n
TOOLS NEEDED
and checking contents
(_
COMBINATION
MEDIUM
PHILLIPS SCREWDRIVER
COMBINATION
SQUARE
MUST
BE TRUE
STRAIGHT
EDGE OF
BOARD
3/4*INCH
THICK
THIS
EDGE
MUST
BE
PERFECTLY
STRAIGHT
/
/
WARNING:
FOR YOUR
OWN SAFETY,
NEVER
DRAW
LIGHT
LINE ON
BOARD
ALONG
THIS
!
AND YOU HAVE READ AND UNDERSTAND
THE
L__
SAFETY AND OPERATIONAL
INSTRUCTIONS.
SHOULD
BE NO GAP
OR OVERLAp
HERE
WHEN
SQUARE
IS FLIPPED
OVER
IN DOTTED
POSITION
Separate all parts from packaging mater als and check
each item with illustration and "Table of Loose Parts."
Make certain all items are accounted for before discard_
ing any packaging material.
CAUTION: To avoid Injury, if any parts are missing,
donot attempt to assemble the Scroll Saw, plug in
the power cord, or turn the switch on until the
missing parts are obtained and installed correctly.
Table of Loose Parts
Qty.
1,16" Scroll Saw (Completely assembled ) ........... 1
2. Owner"s Manual ................................................
1
3. Parts Bag containing: .........................................
1
t Blade, 2 Hex "L" Wrenches, and 1 U-Shaped Bar
NOTE: Hardware to mount this scroll sawto a bench or
leg set is NOT supplied.
See mounting instnJctions for
3
Advertisement
