Advertisement
or su
8, Should any part of this scroll saw bt
fail in any way, or any
perform properly, shut off
and remove
plug from power supply outlet.
Replace damaged,
missing, and/or failed parts before resuming opera-
tion.
9. Think Safety.
Safety is a combination of operator common sense
and alertness wheneverthe
scroll saw is in operation.
The operation of any power tool ca_ result in foreign
objects being thrown into the eyes, which can result in
severe eye damage.
Always wear safety goggles
complying with ANSI Z87.1 (shown on Package) before
commencing power tool operation.
Safety goggles are
available at Sears retail or catalog stores.
WARNING:
ALWAYS KEEP ALERT.
DO NOT AL-
LOW FAMILIARITY (GAINED FROM FREQUENT USE
OF YOUR SCROLL SAW) TO CAUSE A CARELESS
MISTAKE.
ALWAYS REMEMBER
THAT A CARE-
LESS FRACTION OF A SECOND IS SUFFICIENTTO
INFLICT SEVERE INJURY,
f
/
FOR YOUR OWN SAFETY:
\
Read and understand
owner's
manuat before operating SCroll Saw.
B ALWAYS
wear
SAFETY
GOGGLES
complyingwith
ANSI Z87,1.
o PROPERLY
ADJUST
HOLDDOWN,
= Hold workpiece
down
firmly,
o Turn sawoff
and LOCK
SWITCH
before
adjusting
saw, changing
bladeor
leaving
area.
• When
INSTALLING
BLADE:
Blade
teeth must point
down,
Tension
blade by turning
knob
clockwise
one full turn beyond take-up of
alack. Fol!ow
©omplnte
installation
and checking
procedure
in owner's
60 Hz AC oaty, 1.2 empm
EI_'_
electrical connections
3-PRONG PLUG
WARNING: TO AVOID ELECTRICAL HAZARDS, FIRE
HAZARDS,
OR DAMAGE
TO THE
TOOL,
USE
PROPER CIRCUIT PROTECTION.
YOUR SAW IS
WIRED AT THE FACTORY FOR 120V OPERATION.
CON NECT TO A 120-V, 15-AMP, BRANCH CIRCUIT
AND USE A 15-AMP FUSE OR CIRCUIT BREAKER.
TO AVOID SHOCK OR FIRE, IF POWER CORD IS
WORN OR CUT, OR DAMAGED IN ANY WAY, HAVE
IT REPLACED IMMEDIATELY.
\
GROUNDING PRONG
PROPERLY GROUNDED
3-PRONG OUTLET
IF NOT PROPERLY GROUNDED THIS POWER TOOL
CAN CAUSE ELECTRICAL SHOCK- PARTICULARLY
WHEN USED IN DAMP
LOCATIONS
CLOSE TO
PLUMBING,
IF AN ELECTRICAL SHOCK OCCURS
THERE IS ALSO THE POTENTIAL
OF A SECON-
DARY HAZARD SUCH AS YOUR HANDS CONTACT-
ING THE SAWBLADE.
NOT ALL OUTLETS
ARE
PROPERLY GROUNDED.
IF YOU ARE NOT SURE
THAT YOUR OUTLET IS PROPERLY
GROUNDED,
HAVE ITCHECKED
BY A QUALIFIED ELECTRICIAN.
'(our unit has aptug that looks like the one shown.
The ground conductor has a green jacket and is at-
tached to the tool housing at one end and to the ground
prong in the attachment plug at the other end.
This plug requires a mating 3-conductor grounded type
outlet as shown above.
WARNING: TO MAINTAIN PROPERTOOLGROU
hiD-
INGWHENEVERTHE
OUTLETYOU
ARE PLANNING
TO USE FOR THIS POWER TOOL IS OF THE TWO
PRONG TYPE, DO NOT REMOVE OR ALTER THE
GROUNDING PRONG IN ANY MANNER.
USE AN
ADAPTER AS SHOWN AND ALWAYS
CONNECT
THE GROUNDING PRONG TO KNOWN GROUND.
,
ii
4
Advertisement
