Advertisement
ii
i,
i1,,,
i
,
Adjust the blade support by loosening
the screw on
the top of blade support with a hex "L wrench, and
tighten the screw after adjusting.
Adjust the blade holder to the table by loosening the
lockknob. Make sure the foot is positioned properly
against the table, The hex screw (rear of hotd down
foot) may be loosened to adjust hold down fool.
Retighten hex screw after adjustment
is complete.
Adjust the blade holder to the height of workpiece by
adjusting the hold-down foot directly on top of work-
piece and tighten lock knob,
BLADE
HOLID*OOWN
FOOT
ADJf3ST[_G
KNOB
f
_ HOLD-DOWN
FOOT
TO
REST
LIGHTLY
ON
TOP
OF
WORKPIECE
8. Before plugging saw in, use your fingers to raise and
Iowerthe lower arm so the eccentric mechanism turns
at least one cycle to insure the blade is properly in-
stalled.
NOTE: Do not remove guard
\
HOLD_DOWN
ADJUSTING
SCREW
ECCENTRIC
MECHANISM
\
Advertisement
