Restoring All Default Settings - Furuno NX-700A/B Operator's Manual

3. MAINTENANCE & TROUBLESHOOTING
8. When the message "Hit any key" appears on the screen, press any key
(except
The alarm for receiving monitor sounds while the Rx test is being conducted.
9. When the message "[ENT] Finish" appears on the screen, press any key or
wait for one minute with no operation to finish.
Also the test message is printed by pressing PRINT key when the item other
than "None" at Printer on System menu.
10. Press the MENU/ESC key several times to close the menu.
3.5

Restoring all Default Settings

This operation restores all default settings. The following two settings, however,
are not disturbed.
-Received messages
-NAVTEX stations list (See paragraph 2.13.)
1. Press the MENU/ESC key to show the main menu.
2. Press ▼ to choose Service, and then press the ENT key.
3. Press ▲ or ▼ to choose Default Setting, and then press ENT key.
The message "Restore default settings?" appears.
4. Press ◄ to choose "Yes", and then press the ENT key.
The Service menu appears.
5. Press the MENU/ESC key several times to close the menu.
3-6
key) to show the Rx test screen.
[PRINT] Print
[ENT] Finish
Rx test