Mounting Drives; Check Before Mounting; Mounting Procedures; Table 5.8 Setting Check List (Np Model Only) - Fujitsu MAT3300NC/NP Product/Maintenance Manual

5.4

Mounting Drives

5.4.1

Check before mounting

Reconfirm if the setting terminals are set correctly according to Table 5.8 before mounting the NP
model drives in the system cabinet. For setting terminals location, see Section 5.3.
The NC model drives do not require the following check.
Setting Setting contents
No.
terminal
CN2
1 SCSI ID
2 Write protect
3 Motor start mode
4 Force Narrow
5 Force single ended
Terminator power
6
supply
5.4.2

Mounting procedures

Since mounting the drive depends on the system cabinet structure, determine the work procedures
considering the requirements specific to each system. The general mounting method and items to
be checked are shown below.
See Subsection 4.1 for the details of requirements for installing the IDD.
1) With a system to which an external operator panel is mounted, if it is difficult to access the
connector after the drive is mounted on the system cabinet, connect the external operator panel
cable before mounting the drive.
2) Fix the drive in the system cabinet with four mounting screws as follows:
The drive has 10 mounting holes (both sides: 3
four mounting holes of both sides or the bottom. (See Figure 4.5)
Use mounting screws whose lengths inside the drive mounting frame are 5.0 mm or less
when the screws are tightened (see Figure 4.4).
When mounting the drive, be careful not to damage parts on the PCAs.
3) Check to ensure that the DE is not touching the frame on the system side after tightening the
screws. At least 2.5mm of clearance is required between the DE and the frame. (Indicated in
Figure 4.4)
4) When an electric driver is in use, less than device specifications must be used.
C141-E201
Table 5.8 Setting check list (NP model only)
Setting
(Check item) position
CN2
CN2 9 - 10
CN2 11 - 12
CN2 13 - 14
CN2 15 - 16
CN2 23 - 24
Check
1 - 2 ¤ (SCSI ID = __)
3 - 4
5 - 6
7 - 8
¤ Short ¤ Open
¤ Short ¤ Open
¤ Short ¤ Open
¤ Short ¤ Open
¤ Short ¤ Open
2, bottom: 4). Fix the drive by using
Remarks
Upper bus
(DB 8 to 15 PI)
not connected
5-11