Mode Settings; Table 5.7 Default Mode Settings (By Change Definition Command) - Fujitsu MAT3300NC/NP Product/Maintenance Manual

5.3.3

Mode settings

In addition to the previously described settings using setting terminals, the IDD is provided with several
mode settings. The mode settings are enabled by specifying the CHANGE DEFINITION command.
Table 5.7 lists the mode settings and their settings at factory shipment.
Refer to Section 3.1.4 of the SCSI Logical Interface Specifications for details of the command.
Table 5.7
SCSI level
SYNCHRONOUS DATA TRANSFER REQUEST message
sending
UNIT ATTENTION report mode
Reselection retry count
WIDE DATA TRANSFER REQUEST message sending
Reselection time-out delay
Spindle motor start delay time
5-10
Default mode settings (by CHANGE DEFINITION command)
Mode setting Contents
SCSI-3
Not sent from IDD
Reported
Not restricted
Not sent from IDD
250 ms
0 sec (NP)
12 sec × SCSI ID (NC)
C141-E201