12.1.2 Preliminary steps
Before replacing the CMOS battery, perform the following steps:
Ê Follow all procedures described in section
12.1.3 Removing the CMOS battery
Figure 125: Removing the CMOS battery
Ê Press out on the locking spring to eject the depleted CMOS battery (1).
Ê If the CMOS battery cannot be ejected this way, use a toothpick
(recommended) or similar tool as a lever: Insert the toothpick between the
battery and locking spring as shown.
V
CAUTION!
Do not use sharp-edged tools like screw drivers as they may damage
system board components when slipping.
MX130 S2
Upgrade and Maintenance Manual
System board and components
"Opening the server" on page
48.
201