Verifying The Network Connection; Starting The Solaris Operating System; Section 4.3, "Verifying The Network Connection; Section 4.4, "Starting The Solaris Operating System - Fujitsu SPARC Enterprise M3000 Installation Manual

4.3

Verifying the Network Connection

This section explains how to verify the user network connection made as described
in Section 4.2, "Connecting to the Network" on page
1. Set the mode switch on the operator panel to the Service position.
2. Press the Power button on the operator panel to power on the server.
3. Confirm the status of the LINK SPEED LED (see
connected as described in
When it is on in amber, the communication speed of LAN port is 1G bps.
■
When it is on in green, the communication speed of LAN port is 100M bps.
■
When it is off, the communication speed of LAN port is 10M bps.
■
FIGURE 4-2
4.4

Starting the Solaris Operating System

Start the Solaris
When performing this operation after the operations in
Network Connection" on page
Note – Solaris OS is pre-installed in the hard disk drive (HDD) of slot#0. When you
start Solaris OS from this HDD, a message appears to configure the Solaris OS in line
with the environment in use.
1. Set the mode switch on the operator panel to the Service position.
2. Press the Power button on the operator panel to power on the server.
Section 4.2, "Connecting to the Network" on page
Location of LINK SPEED LED
LINK SPEED LED
GbE port on the rear panel
TM
Operating System, as described in this section.
4-2.
FIGURE 4-2
4-3, start from Step 5.
Chapter 4 Connecting the Domain to the Network
) of the port
Section 4.3, "Verifying the
4-2.
4-3