Napoleon PTH31GT User Manual

Napoleon PTH31GT User Manual

Bellagio commercial gas patio torch
Hide thumbs Also See for PTH31GT:

Advertisement

WARNING!
For Outdoor Use Only.
WARNING!
Improper installation, adjustment, alteration, service or maintenance can cause property damage,
injury or death. Read the installation, operating and maintenance instructions thoroughly before installing or servicing
this equipment.
DANGER
IF YOU SMELL GAS:
• Shut off gas to the appliance.
• Extinguish any open flame.
• If odor continues, keep away from the
appliance and immediately call your gas
supplier or fire department.
Notice to Installer: Leave these instructions with the gas patio torch owner for future reference.
Fax: (705)725-2564 email: wecare@napoleonproducts.com web site: www.napoleongrills.com
Napoleon Appliance Corp.,
214 Bayview Dr., Barrie, Ontario, Canada L4N 4Y8 Phone: 1-866-820-8686
BELLAGIO COMMERCIAL GAS PATIO TORCH
Do not try to light this appliance without
reading the "LIGHTING" instructions section of
this manual.
Do not store or use gasoline or other flammable
liquids or vapors in the vicinity of this or any
other appliance. An L.P. cylinder not connected
for use must not be stored in the vicinity of
this or any other appliance. If the information
in these instructions is not followed exactly, a
fire or explosion may result, causing property
damage, personal injury or death.
APPLY SERIAL NUMBER LABEL FROM CARTON
Serial No.
XXXXXX000000
MODEL NO.
PTH31GT
WARNING
N415-0219 OCT 26/11

Advertisement

Table of Contents
loading

Summary of Contents for Napoleon PTH31GT

  • Page 1 WARNING! For Outdoor Use Only. WARNING! Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury or death. Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment. APPLY SERIAL NUMBER LABEL FROM CARTON Serial No.
  • Page 2: Conditions And Limitations

    NAPOLEON products are designed with superior components and materials, and are assembled by trained craftsmen who take great pride in their work. Every component has been thoroughly inspected by a qualified technician before packaging and shipping to ensure that you, the customer, receive the quality product you expect from NAPOLEON. Napoleon Patio Torch President's Warranty NAPOLEON warrants the materials and workmanship in your new NAPOLEON Patio Torch against defects for a period of...
  • Page 3: Safe Operating Practices

    WARNING! Failure to follow these instructions could result in property damage, personal injury or death. Read and follow all warnings and instructions in this manual prior to operating this gas patio torch. Safe Operating Practices • Read the entire instruction manual before operating the patio torch. •...
  • Page 4: General Information

    General Information This gas torch is certified under Canadian and American national standards, CSA 2.37a – 2008 and ANSI Z83.26a - 2008 respectively for outdoor patio heaters and must be installed to conform with local codes. When an appliance is for connection to a fixed piping system, the installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54, Natural Gas and Propane Installation Code, CSA B149.1, or Propane Storage and Handling Code, B149.2.
  • Page 5 Propane Cylinder Installation: Set cylinder into hole in bottom shelf. Tighten strap over cylinder to secure it in place. Loop Strapping through slots in bottom shelf and secure over top of propane tank as illustrated Cylinder Connection: Ensure the gas regulator hose is kink free. Remove the cap from the cylinder fuel valve. Insert the black QCC1 regulator nipple onto the QCC1 fuel valve.
  • Page 6 Leak Testing Instructions WARNING! A leak test must be performed annually and each time a cylinder is hooked up or if a part of the gas system is replaced. WARNING! Never use an open flame to check for gas leaks. Be certain no sparks or open flames are in the area while you check for leaks.
  • Page 7: Lighting Instructions

    Lighting Instructions WARNING! Never use the torch while it is raining, the glass tube could crack or break causing serious injury. WARNING! Ensure burner controls are in the off position. Slowly turn on the gas supply valve. 1. Turn burner control to ‘LIGHT’ position.
  • Page 8 Operating The Patio Torch Initial Lighting: When lit for the first time, the patio torch emits a slight odor. This is a normal temporary condition caused by the “burn-in” of internal paints and lubricants used in the manufacturing process and does not occur again.
  • Page 9: Maintenance / Cleaning Instructions

    Maintenance / Cleaning Instructions This patio torch must be thoroughly inspected and serviced annually by a qualified service person. WARNING! Always wear protective gloves and safety glasses when cleaning your patio torch. WARNING! To avoid the possibility of burns, maintenance should be done only when the patio torch is cool.
  • Page 10: Troubleshooting

    Troubleshooting Problem Possible Causes Solution Low heat / Low flame when For propane - improper lighting Ensure lighting procedure is followed carefully. The valve turned to high. procedure. valve must be in the off position when the tank valve is turned on. Turn tank on slowly to allow pressure to equalize.
  • Page 11: Getting Started

    CAUTION! During unpacking and assembly we recommended you wear work gloves and safety glasses for your protection. Although we make every effort to make the assembly process as problem free and safe as possible, it is characteristic of fabricated steel parts that the edges and corners might be sharp and could cause cuts if handled incorrectly.
  • Page 12 7 X (M5 X 8mm) Disassemble the control box (2) from the plate cover (7) and the middle plate (1) by removing the (M5 x 8mm) screws (17). These parts were assembled at the factory to protect the parts during shipping. Désassemblez le boîtier de contrôle (2) et le couvercle de plaque (7) de la plaque centrale (1) en retirant les vis (M5 x 8 mm) (17).
  • Page 13 16 X (M5 X 8) Assemble the four upper supports (5) to the lower supports (4) using the (M5 x 8mm) screws (17). The upper plate (6) is then assembled to the upper supports (5) using the (M5 x 8mm) screws (17). Fixez les quatre pattes supérieures (5) aux pattes inférieures (4), à...
  • Page 14 3 X (M5 X 8) Install an AA battery (20) into the control box. Assemble the control box (2) onto the bottom of the middle plate (1) using the (M5 x 8mm) screws (17). Note: The control knob is to face to the front of the torch where the magnet is installed in the middle plate.
  • Page 15 Carefully install the glass tube (8) by lifting up and inserting through the center hole in the upper plate (6). Ensure the black silicone ring is attached to the lower edge of the glass tube as To aid in installation place black illustrated.
  • Page 16 12 X (M5 X 8) Attach the three side panels (15) to the torch using the (M5 x 8mm) screws (17). Note: Do not cover the front side where the control knob is. Fixez les trois panneaux latéraux (15) sur le torche-patio, à l’aide de vis (M5 x 8 mm) (17).
  • Page 17 Propane Only – Proper Hose Connection Propane Seulement - Branchement Adéquat Du Boyau WARNING! Ensure the hose does not contact any high temperature surfaces, or it may melt and leak causing a fire. AVERTISSEMENT! Assurez-vous que le boyau ne touche à aucune surface à haute température sinon il risque de fondre, de provoquer une fuite et causer un feu.
  • Page 18 Leak Testing Instructions WARNING! A leak test must be performed annually and each time a cylinder is hooked up or if a part of the gas system is replaced. WARNING! Never use an open flame to check for gas leaks. Be certain no sparks or open flames are in the area while you check for leaks.
  • Page 19: Parts List

    Parts List Item # Description/Part # Picture Comments Middle Plate - LH230-1-3-0 Control Box Assy - LH200-30 Preassembled in the Middle Includes: Plate Burner LP - LH100-3-8-0 Burner NAT - LH200-3A-8-0 Pilot LP - LH100-3-7A-0 Pilot NAT - LH200-3A-7-0 Valve Assy LP - LH200-3-2-0 Valve Assy NAT - LH200-3A-2-0 Pilot Tube - LH200-3-4-0 Igniter - LH100-3-10...
  • Page 20 Parts List Item # Description/Part # Picture Comments Tube Connectors - LH200-8 Upper Protective Guards LH230-7 Fixing Brackets - LH100-10 Side Panel - LH230-11A Front Panel - LH230-12-3-0 A chain is preassembled in this panel Screw M5 x 8mm Preassembled in relative parts Knob - LH100-12-1 Chain - LH100-12-2-0...
  • Page 21: Ordering Replacement Parts

    KEEP YOUR RECEIPT AS PROOF OF PURCHASE TO VALIDATE YOUR WARRANTY. Ordering Replacement Parts Warranty Information MODEL: DATE OF PURCHASE: SERIAL NUMBER: (Record information here for easy reference) Before contacting the Customer Care Department, check the NAC Website for more extensive cleaning, maintenance, troubleshooting and parts replacement instructions at www.napoleongrills.com.
  • Page 22 FAX TO: 705 727 4282 ACCESSORIES & PARTS ORDER FORM PLEASE PRINT CLEARLY CONTACT NAME:______________________________________________________________________ SHIP TO :_____________________________________________________________________________ _________________________________________________________________________________________ _________________________________________________________________________________________ _________________________________________________________________________________________ TEL :_________________________________ FAX :______________________________ EMAIL: __________________________________________________________________ VISA OR MASTERCARD # :_______________________________________ EXPIRY DATE: _____________ SIGNATURE:_____________________________________________________________________________ QUANTITY PART NUMBER DESCRIPTION TAXES MAY APPLY SHIPPING EXTRA IF CONFIRMATION IS REQUIRED PLEASE INCLUDE A FAX NUMBER OR EMAIL ADDRESS...
  • Page 23 www.napoleongrills.com...

Table of Contents