[SECURITY] menu
9) Press ◀▶ to switch between enable/
disable.
▶
z The setting will change as follows each time
you press the button.
[ENABLE]
[ENABLE]
Enables button operations.
[DISABLE]
Disables button operations.
10) Press ▲▼ to select [APPLY], and
press the <ENTER> button.
▶
z The confirmation screen is displayed.
11) Press ◀▶ to select [OK], and press
the <ENTER> button.
Note
z When a button operation is performed on the
device set to [DISABLE], the [CONTROL DEVICE
PASSWORD] screen is displayed.
Enter the control device password.
z The [CONTROL DEVICE PASSWORD] screen
will disappear when there is no operation for
approximately ten seconds.
z It will not be possible to turn off the power (standby
status) if the operations of both of [CONTROL
PANEL] and [REMOTE CONTROL] are set to
[DISABLE].
z When the setting has completed, the menu screen
will disappear. To operate continuously, press the
<MENU> button to display the main menu.
z Even when button operation on the remote control
is disabled, the <ID SET> button and the <ID ALL>
button are enabled.
124 - ENGLISH
[CONTROL DEVICE
PASSWORD CHANGE]
The control device password can be changed.
[DISABLE]
1) Press ▲▼ to select [CONTROL
2) Press the <ENTER> button.
3) Press ▲▼◀▶ to select the text, and
4) Press ▲▼◀▶ to select [OK], and
Attention
z The initial password when used for the first time or
after initializing all the user data is "AAAA".
z Change the password periodically that is hard to
guess.
DEVICE PASSWORD CHANGE].
▶
z The [CONTROL DEVICE PASSWORD
CHANGE] screen is displayed.
press the <ENTER> button to enter the
text.
press the <ENTER> button.
▶
z To cancel, select [CANCEL].