Connecting To A Computer (Usb Terminal); Turning The Power On - Yamaha YPG635MM Owner's Manual

Turn down the volume by turning the [MASTER VOL-
UME] control to the left and press the [STANDBY/ON]
switch to turn on the power. Press the [STANDBY/ON]
switch again to turn the power OFF.
● Music Rest

Connecting to a Computer (USB Terminal)

Connect the instrument's USB terminal to the USB ter-
minal of a computer, and you can transfer performance
data and song files between the two (page 105). To use
the USB data-transfer features you'll need to do the fol-
lowing:
Installation of the USB-MIDI driver is described on
page 113.

Turning the Power On

Backup data in the flash memory is loaded to the instru-
ment when the power is turned on. If no backup data
exists on flash memory, all instrument settings are
restored to the initial factory defaults when the power is
turned on.
• First, make sure the POWER switch on the instru-
ment is set to OFF, then use an AB type USB cable
to connect the instrument to the computer. After
making the connections, turn the instrument's
power on.
• Install the USB-MIDI driver on your computer.
CAUTION
• Even when the switch is in the "STANDBY" position, electricity is
still flowing to the instrument at the minimum level. When you are
not using the instrument for a long time, make sure you unplug the
AC power adaptor from the wall AC outlet.
CAUTION
• Never attempt to turn the power off when a "WRITING!" message
is shown in the display. Doing so can damage the flash memory
and result in a loss of data.
Insert the music rest into
the slots as shown.
DGX-630/YPG-635 Owner's Manual
Setting Up
15