Connecting To A Computer (Usb To Host Terminal); Turning The Power On - Yamaha Arius YDP-V240 Owner's Manual

Connecting to a Computer (USB TO HOST terminal)

Computer
USB cable
Power indicator
1
Turn down the volume by turning the [MAS-
TER VOLUME] control to the left.
2
Check the power cord to make sure it is
connected properly. (See page 116.)
3
Press the power switch to turn on the
power.
Press the power switch again to turn the power OFF.
NOTE
Power indicator
• If you forget to turn off the power to the instrument and close the key
cover, the power indicator will remain lit, indicating that the power is still
on.
USB TO HOST
terminal
USB
TO HOST

Turning the Power On

Connect the instrument's USB TO HOST terminal to
the USB terminal of a computer, and you can transfer
performance data and song files between the two (page
104). To use the USB data-transfer features you'll need
to do the following:
• First, make sure the POWER switch on the instru-
ment is set to OFF, then use an AB type USB cable
to connect the instrument to the computer. After
making the connections, turn the instrument's
power on.
• Install the USB-MIDI driver on your computer.
Installation of the USB-MIDI driver is described on the
"Accessory CD-ROM Installation Guide".
Power switch
Backup data in the flash memory is loaded to the instru-
ment when the power is turned on. If no backup data
exists on flash memory, all instrument settings are
restored to the initial factory defaults when the power is
turned on.
CAUTION
• Even when the switch is in the "off" position, electricity is still
flowing to the instrument at the minimum level. When you are not
using the instrument for a long time, make sure you unplug the AC
power cord from the wall AC outlet.
CAUTION
• Never attempt to turn the power off when a "WRITING!" message
is shown in the display. Doing so can damage the flash memory
and result in a loss of data.
Setting Up
11
Owner's Manual