Statistics Defined - Enterasys IRM2 User Manual

To open the board-level Statistics window:
1. Click on the appropriate Board number to display the board menu.
2. Drag down to Statistics... and release. The board-level Statistics window will
To access the port-level Statistics window:
1. Click on the appropriate Port to display the port menu.
2. Drag down to Statistics... and release. The port-level Statistics window will
The Board and Port Statistics windows are the same as the Statistics window
displayed in
selected board or port.

Statistics Defined

The statistics window displays the statistical counts accumulated since the IRM2
was last reset or since the last time the
select
The statistics windows display the following information:
Active Users (Available with Release Version 2.00 Firmware and Above)
Displays the number of users (identified by MAC [Ethernet] address)
communicating via a port on the IRM2-managed hub. For an individual port, if
Active Users is greater than one, it indicates that a port is supporting a trunk
connection and will not respond to port locking. Refer to Chapter 4, Source
Address Functions, in this guide for more information.
Bytes
Displays the total number of bytes (good packets only) that have been processed
by the device, board, or port. Note that this byte count does not include errors.
Broadcasts (Available with Release Version 2.00 Firmware and Above)
Displays the total number of broadcast frames that have been processed by the
device, board, or port. Broadcast packets have a single address recognized by
each station on the net; this address is designated in IP address form as
255.255.255.255, or in MAC hexadecimal form as FF-FF-FF-FF-FF-FF. ARP and
RARP requests sent by bridges and routers are broadcast messages.
Packets
Displays the total number of good packets processed by the device, board, or
port. Again, note that the packet count does not include errors.
Statistics
appear.
appear.
Figure 3-1, except that they display statistics applicable to the
at any time to refresh the counters and restart at zero.
button was selected. You can
Statistics
3-3