Configuring The Front Panel Repeater Port Association - Enterasys IRM2 User Manual

The IRM2 Chassis View
To do so:
1. Select Repeater from the Chassis View menu; drag down to Restart... and
The IRM2 will be restarted as if it had just been powered up.

Configuring the Front Panel Repeater Port Association

Using the Port Association option for the IRM2, you can set which of the IRM2's
front panel ports will act as a repeater interface for a connected network segment.
Before selecting this option, be sure that you will not disrupt network activity. If you
!
disconnect the segment with which you are communicating with the IRM2, you will lose
contact with the device, and you will have to reset the original port association through
CAUTION
local management.
To change the port association:
1. Click on Port 1 or Port 2 on Board 1 (the IRM2 module). The Port pull-down
2. Click on Port Association.... The Port Association window,
2-16
release.
menu will appear.
appear.
Figure 2-9. Repeater Port Association
Click on the appropriate radio button:
indicates that Port 2 (the Fiber Optic Link Port) will be made
the active repeater interface for an attached fiber segment, and that Port 1
(the AUI Port) will be disabled.
indicates that Port 1(the AUI port) will be used to repeat
data from its attached network segment, and Port 2 (Fiber Optic Link Port) will
be disabled.
Figure 2-9, will
Managing the Hub