Using Window Buttons - Enterasys IRM2 User Manual

IP Address
Displays the device's IP (Internet Protocol) address. This will be the IP address
used to define the device icon. IP addresses are assigned via Local Management
for the IRM2; they cannot be changed via NetSight Element Manager.
Location
Displays the user-defined location of the device. The location is entered through
the System Group window; see the Generic SNMP User's Guide for details.
MAC Address
Displays the manufacturer-set MAC address of the IRM2 with which NetSight
Element Manager is communicating. This address is factory-set and cannot be
altered.
Informational fields describing the boards and/or ports being modeled are also
displayed in most windows:
Board Number
Displays the number indicating the position of the monitored board in the chassis.
Board Name
Displays the user-entered name for the board. You can change the board name via
the Name option available from the Board menu.
Port Number
Displays the number of the monitored port.
Port Name
Displays the user-defined name of the port. You can change the port name via the
Name option available from the Port menu.
Active Users
Indicates the number of users processing information through the IRM2 repeater,
board, or port, as determined by MAC addresses.
Uptime
Displays the amount of time, in a days hh:mm:ss format, that the IRM2 has been
running since the last start-up.

Using Window Buttons

The
exit a window and terminate any unsaved changes you have made. You may also
have to use this button to close a window after you have made any necessary
changes and set them by clicking on an
Software Conventions
button that appears at the bottom of most windows allows you to
, , or
Introduction
button.
1-5