Ground Drive - Craftsman 917.28008 Operator's Manual

1
The operation of any tractor can result in foreign objects thrown into |
the eyes, which can result in severe eye damage. Always wear safety I
glasses or eye shields while operating your tractor or performing any |
adjustments or repairs. We recommend standard safety glasses or a |
wide vision safety mask worn over spectacles, |
HOW TO USE YOUR TRACTOR
TO SET PARKING BRAKE
Your tractor is equipped with an operator
presence sensing switch. When engine is
running, any attempt by the operator to leave
the seat without first setting the parking brake
will shut off the engine.
!. Depress brake pedal (B) all the way down
and hold.
2. Pull parking brake lever (C) up and hold,
release pressure from brake pedal (B),
then release parking brake lever. Pedal
should remain in brake position. Make
sure parking brake will hold tractorsecure.
NOTE: Failure to move throttle control
between half and full speed (fast) posi-
tion, before stopping, may cause engine
to "backfire".
• Turn ignition key (F) to "STOP" position
and remove key. Always remove keywhen
leavingtractorto prevent unauthorized use.
• Never use choke to stop engine.
IMPORTANT: Leaving the ignition switch in
any position other than "STOP" will cause the
battery to discharge and go dead,
NOTE: Under certain conditions when tractor
is standing idle with the engine running, hot
engine exhaust gases may cause "brown-
ing" of grass, To eliminate this possibility,
always stop engine when stopping tractor
on grass areas.
J:I, CAUTION: Always stop tractor com-
pletely, as described above, before leaving
the operator's position.
STOPPING
MOWER BLADES -
• To stop mower blades, move attachment
clutch controtto disengaged position (l_'t),
(__) Attachment (1_) Attachment
C_utchControl ClutchControl
"Engaged .... Disengaged"
GROUND DRIVE -
* Tostopgrounddrive, depress brake pedal
nit the way down,
IMPORTANT: Forward and reverse drive
pedals return to neutral position when not
depressed.
ENGINE -
- Move throttle control (D) between half and
full speed (fast) position.
TO USE THROTTLE CONTROL (D)
Always operate engine at full speed (fast).
• Operating engine at less than full speed
(fast) reduces engine's operating ef-
ficiency.
• Full speed (fast) offers the best mower
performance.
TO USE CHOKE CONTROL (N)
Use choke control whenever you are starting
a cotd engine. Do not use to start a warm
engine.
• To engage choke control, pull knob out.
Slowly push knob in to disengage.
15