How To Set The Drift Cutters
Drift cutters are used to cut a path
through snow deeper than the auger
housing.
1. Loosen the wingnuts that secure
the drift cutters to the auger hous-
ing. See Figure 15.
2, Raise the drift cutters to the de-
sired height.
3. Tighten the wingnute.
Wingnut
Drift Cutter
Figure 15
_" CHECKLIST
Before you operate your new snow
thrower, to ensure that you receive the
best performance and satisfaction from
this quality product, please review the
following checklist:
_" All assembly instructions have been
completed.
_" The discharge chute rotates freely.
No remaining loose parts in carton.
While learning how to use your snow
thrower, pay extra attention to the fol-
lowing important items:
_"
Engine oil is at proper level.
_"
Make sure gas tank is filled properly
with clean, fresh, unleaded gasoline.
_"
Become familiar
with all controls-
their location and function. Operate
controls before starting engine.
F_)01162J
12