Tools Required - Craftsman 536.881121 Owner's Manual

Read and follow the assembly and ad-
justment instructions for your snow
thrower. All fasteners are in the parts
bag. Do not discard any parts or materi-
al until the unit is assembled.
WARNING: Before doing any
assembly or maintenance to
the snow thrower, remove the
wire from the spark plug.
_hl ARNING: Always wear
safety glasses or eye
shields while assembling
snow thrower.
NOTE: In this instruction book, left
and right describe the location of a
part from the operator's position be-
hind the unit.
Tools Required
1 Knife
Pliers
1/2 inch open end wrenches
9/16 inch open end wrenches
3/4 inch open end wrenches
3/8 inch open end wrenches
Measuring tape or ruler
Screwdriver
Figure 1 shows the snow thrower in the
shipping position.
Clutch
Control
Cable
Figure 1
Figure 2 shows the snow thrower com-
pletely assembled.
Traction Dnve
Lever
Remote
Chute
Crank
Lever
Drift
Cutter
\
Chute
Deflector
Height
Adjust
Skid
Figure 2
How To Remove The Snow
Thrower From The Carton
1. Locate the two tear tabs at the bot-
tom of the carton.
2. Pull the tear tape no more than
twelve inches (30.48cm.) at a time.
Re-grasp tape next to the carton
F_)01162J
and pull again. Repeat until all the
tape is torn off.
3. After the tape has been completely
removed from the carton, remove
the carton from the base. Cut all
four corners and fold the sides to-
ward the center for easy disposal.