Drift Cutters; Tire Pressure; Lamp Wiring Harness - Craftsman C459-52213 Operator's Manual

Drift Cutters (If equipped)
Drift cutters should be used when operating the snow thrower in heavy
drift conditions.
• On models so equipped, drift cutters and hardware are assembled
to the auger housing inverted.
• Remove the carriage bolts and hex nuts securing the drift cutters to
the housing.
• Reposition drift cutters so they face forward as shown in Figure 14.
Secure with hardware previously removed.
If your unit is not equipped with drift cutters, you may contact
1-800-4MY-HOME for information regarding price and availability.
Lamp Wiring Harness (If equipped)
The post on the cable tie attaching the lamp wiring harness to the
lower handle should be plugged into the hole in the lower handle. Pull
the slack portion of the wiring harness through the cable tie to prevent
interference with the recoil starter handle. See Figure 15.
Figure 14
Figure 15
ASSEMBLY

Tire Pressure

The tires are over-inflated for shipping purposes. Check the tire
pressure before operating the snow thrower. Refer to the tire side wall
for tire manufacturer's recommended psi and deflate (or inflate) the
tires as necessary.
Under any circumstance do not exceed manufacturer's recom-
mended psi. Equal tire pressure should be maintained at all times.
Excessive pressure when seating beads may cause tire/rim
assembly to burst with force sufficient to cause serious injury. Refer
to sidewall of tire for recommended pressure.
10
WarnIng