Exmark LAZER Z X-SERIES Operator's Manual page 41

Figure 27
1. Foot lever
2. Height of cut pin
6. Insert the height adjustment pin into the 3 inch
(7.6 cm) cutting height location.
7. Release the transport lock and allow the deck to
lower to the cutting height.
8. Raise the discharge deflector.
9. Measure from the level surface to the front tip of
the center blade. The measurement should read
3 inches (7.6 cm).
Note: In most conditions, the back blade tip
should be adjusted 1/4 inch (6.4 mm) higher than
the front.
3. Transport lock
1. 3 1/4 inches (8.3 cm)
2. Back blade tip
3. Front blade tip
10. Loosen the jam nuts on the top of each deck
link. Fine tune the adjuster on the front deck
lift assembly by turning it to get 3 inch (7.6 cm)
height (see Figure 29).
To increase the height, turn the adjuster clockwise;
to decrease, turn counterclockwise.
1. Adjuster link
2. Jam nut
11. The back tip of the blade should measure 3
1/4 inches (8.3 cm). Fine tune rear adjusters as
required.
41
Maintenance
Figure 28
4. 3 inches (7.6 cm)
5. Level surface
Figure 29
3. Adjuster