Check Seat Belt; Check For Loose Hardware; Service Air Cleaner; Change Engine Oil - Exmark LAZER Z X-SERIES Operator's Manual

Figure 23
1. Engaged

Check Seat Belt

Service Interval: Before each use or daily
Visually inspect seat belt for wear, cuts, and proper
operation of retractor and buckle. Replace before
operating if damaged.

Check for Loose Hardware

Service Interval: Before each use or daily
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Visually inspect machine for any loose hardware
or any other possible problem. Tighten hardware
or correct the problem before operating.

Service Air Cleaner

Service Interval: Every 250 hours—Replace
the primary air cleaner
element — check
secondary air cleaner
element; replace if dirty.
(May need more often
under severe conditions.
See the Engine Owner's
Manual for additional
information.)
Every 500 hours—Replace
the secondary air cleaner
element (May need more
often under severe
conditions. See the
2. Partially engaged — Do
Not operate with ROPS
in this condition.
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. See the Engine Owner's Manual for maintenance
instructions.
Check Air Filter Assembly (if
equipped)
Service Interval: As required
Important: To prevent engine damage, always
operate the engine with both air filters and cover
installed.
1. When checking or replacing the air filter element,
make sure the air filter assembly is installed in the
brackets.
2. Position the air cleaner cover so that the
breather valve does not interfere with the throttle
mechanism.
1. Air cleaner cover
2. Throttle mechanism
3. Secure the cover with latches.

Change Engine Oil

Service Interval: After the first 5 hours
35
Maintenance
Engine Owner's Manual
for additional information.)
Figure 24
3. Breather valve
Every 100 hours/Yearly
(whichever comes first)