Table of Contents
Advertisement
SUPPLY
CONDUIT
FIGURE 1. REAR VIEW - BOTTOM SECTION SERVICE PANEL REMOVED
BEVERAGE SYSTEM
" B" , Models: contain beverage faucets only and must be supplied with cold product from any remote cold plate
or refrigerated soda factory. " BC"units have a built-in cold plate, in addition to the beverage faucets and are de-
signed to be supplied direct from syrup tanks and carbonator with no additional cooling required.
Installation
NOTE:
This work should be done by a qualified service person.
1. Locate the required openings in the counter top for the beverage lines as shown in Figure 2.
2. For " b"models, carefully pull the beverage tubes through the bottom opening in the unit and through the
clearance opening in the counter.
3. For " BC"models, tube fittings are provided at the rear of the unit on the cold plate for syrup and water line
hook up.
4. Connect the beverage system product lines as indicated in figure 3 (" B"UNITS) AND fIGURE 4 (" BC"
Units).
NOTE:
That the hoses are marked with number (1 through 6) for syrup connections and "CW" for
carbonated water connection.
90846
BLACK
(HOT)
WHITE
(NEUTRAL)
GREEN
(GROUND)
115V 60 HZ, 1PHASE
4
Advertisement
Table of Contents
