Enterasys 6H308-24 Installation Manual page 40

Using LANVIEW
Table 4-1 LANVIEW LEDs (Continued)
LED Color
TX Off
(Transmit)
Green
Amber
Red
4-4 Troubleshooting
State
Port enabled, and no
activity. If STA is
enabled and there is a
valid link, this led should
flash green every two
seconds indicating that
BPDUs are being sent.
Flashing. Indicates
activity. Rate indicates
data rate.
Blinking. Port in
standby. The port may be
disabled due to Spanning
Tree.
Flashing. Indicates
collision rate.
Solid. Diagnostic failure.
Recommended Action
Ensure that the STA is enabled and that
there is a valid link.
Contact Enterasys Networks for technical
support.
None.
Ensure that the port is not disabled.
Contact Enterasys Networks for technical
support.
None, unless there is a high amount of
activity. In this case, check for network
configuration problems or a defective
device.
Contact Enterasys Networks for technical
support.