Rear Panel Connectors; Table 4 Types Of Connector - Ericsson RX8200 User Manual

Installing the Equipment
The Technical Earth is not a Protective earth for electric shock protection.
This unit must be correctly earthed through the molded plug supplied. If the local
mains supply does not have an earth conductor do not connect the unit. Contact
Customer Services for advice.
Before connecting the unit to the supply, check the supply requirements in Annex B
of the Reference Guide.
2.4

Rear Panel Connectors

Always use the specified cables supplied for signal integrity and compliance with
EMC requirements (see the Reference Guide).
Note:
INPUT MODULE
RX8200
Sample configuration
with: Satellite input,
frame sync, HD video
output, IP Transport
Stream output and 2x
Audio output modules
installed.
Figure 1
Table 4
Type of Connector
RF IN 1,2,3 & 4
AUDIO OUT 1,2,3 & 4
FRAME SYNC
ALARM
IP OUT 1 & 2
CVBS
COMPONENT VIDEO
10 (44)
Rear panel connectors may differ, depending on the options selected.
RF IN 1-4 AUDIO OUT (1)
IP OUT 1-2 CVBS COMPONENT
VIDEO
Rear Panel Connectors
Types of Connector
Description
F-type connectors for DVB or DVB-S2 modulated input
feed.
9-way male D-type connectors for analogue and
balanced digital audio output.
75 Ω BNC connector for frame synching input.
9-way male D-type connector for alarm signal output.
8-way RJ-45 connectors for 1000BaseT IP output feed &
de-encapsulated IP data
75 Ω BNC connector for SD composite video output.
9-way male D-type connectors for component video
output.
Warning!
AUDIO OUT (2)
1-2 3-4
ASI/HD-SDI/SD- ASI INPUT
SDI OUT 1-3
ALARM
FRAME AC POWER
SYNC
CONTROL TECHNICAL
1-2
EARTH
EN/LZT 790 0009 R1A 2011-03-30