Configuring The Inputs - Ericsson RX8200 User Manual

2. Switch on the AC power supply to the unit at the wall or rack outlet.
Note:
3. After a short period of initialization the following screen is displayed on the Front
4. During initialization, confirm that the Status LED is on and all Up, Down, Left,
3.2.2 Power Up Operating Modes
When the equipment is switched on it will assume the control mode that was set
when the power was turned off. This could be either:
•
•
3.3

Configuring the Inputs

3.3.1 Transport Stream (ASI) Input
To configure the unit for ASI input:
1. Select ASI input from sub-menu Select Input.
3.3.2 Satellite (DVB-S or DVB-S2) Input (if fitted)
Ensure that the incoming feed is connected to connector RF IN 1.
To configure the unit for Satellite input, navigate to the front panel Input menu
Source # Configure menu and carry out the following steps:
1. Select SAT input
2. Set the LNB frequency
3. Set the Satellite frequency
4. Set the Symbol Rate
5. Set the Modulation scheme and FEC
6. Set the Roll-Off
7. Set the set the LNB power output
EN/LZT 790 0009 R1A 2011-03-30
The RX8200 Receiver does NOT contain a power on/off switch.
Panel:
Right, Edit and Save pushbuttons are lit.
Local Front Panel/Web Browser control
Director NCP control.
Quick Start Guide: Connect-Power-Configure
INITIALIZING
4.3.2 (Bank 0)
13 (44)