Maintenance - Craftsman 536.884791 Owner's Manual

16. Never direct d ischarge
at bystanders or
allow anyone in front of the snow
thrower.
17. Disengage power to the auger/impeller
when snow thrower is transported or
not in use.
18. Use only attachments and accessories
approved by the manufacturer of the
snow thrower (such as tire chains,
electric start kits, etc).
19. Never operate the snow thrower
without good visibility or light. Always
be sure of your footing, and keep a firm
hold on the handles. Walk; never run.
MAINTENANCE AND STORAGE
1. Check shear bolts and other bolts
frequently for proper tightness to be
sure the snow thrower is in safe
working condition.
2. Never store the snow thrower with fuel
in the fuel tank inside a building where
ignition sources are present such as
hot water and space heaters, clothes
dryers, and the like. Allow the engine
to cool before storing in any enclosure.
3. Always refer to operator's manual
instructions for important details if the
snow thrower is to be stored for an
extended period.
Contents of Parts Bag
4. Maintain or replace safety and instruc-
tion labels, as necessary.
5. Run the snow thrower a few minutes
after throwing snow to prevent freeze-
up of the auger/impeller.
/_k WARNING: This snow thrower is for
use on sidewalks, driveways and other
ground level surfaces.
Caution should be exercised while using on
steep sloping surfaces. DO NOT USE
SNOW THROWER ON SURFACES
ABOVE GROUND LEVEL such as roofs of
residences, garages, porches or other such
structures or buildings.
3 - Carriage Bolts, 5/16-18xl .00 In. 5 - Flatwashers 11/32 In. 3 -Hex Nylon Nuts, 5/16-18
4
-Owner's Manual (not shown)
11 - Fuel Stabilizer(not shown)
1 - Warranty Card (not shown) _ _
2- Parts Bags (not shown)
I I \\
* Non-AssemblyPartsare found in your Tool Box located
I I \\
on top of your belt cover.
Do II
*2 - Spare Spacers I
2 - 5/16 In. Hsx Nuts |/_1_
(_ _J *2 - Shear Pins
_ _1 " _tatdehoMw°nt °rcC°a_dize )