Table of Contents
Advertisement
Adding Detergent and Rinse Agent (co.tioue¢
Opening
the Detergent
Dispenser
Cover
NOTE:
To open the
detergent
dispenser
cover,
press the blue release
in the direction
shown
in Figure
23. Pressing
down
on the
release
tab will not open the cover.
Press
the blue
Figure 23
release
tab in
the
direction
shown
by the
arrow in
Figure
23.
The cover will slide open to the right.
Filling the Rinse Agent Dispenser
Open the rinse agent dispenser
by pressing
the
star on the cover with your index finger while
lifting the tab with your thumb as shown
in Figure
24.
Figure 24
i
Add liquid rinse agent to the dispenser
as shown
in Figure 25A until the rinse agent reservoir
is full.
Wipe up any excess
rinse agent that puddles
when the dispenser
reservoir
is full.
Figure 25
Return the rinse agent dispenser
cover to its shut
position
and press it firmly so that the cover
snaps shut.
NOTE:
Figure
25B represents
a completely
empty
rinse
agent
reservoir.
Refill the rinse agent dispenser
when the rinse
agent reservoir
level indicator
as shown in Figure
25B begins to show a silver background
with
black lines or when the Refill Rinse Agent
indicator
comes
on.
NOTE: After filling the rinse agent dispenser,
the
Refill Rinse Agent Indicator
will go out in a few
minutes
after the dishwasher
door is shut.
Rinse Agent Dispenser
Regulator
The amount
of rinse agent dispensed
can be
regulated
to control spotting
and streaking.
The
Rinse Agent Dispenser
Regulator
as shown
in
Figure 26 leaves our factory set at 4.
Figure 26
To adjust
the amount
of rinse
agent
dispensed:
1. Open the rinse agent dispenser
cover.
2. If your dishes are streaked
after washing,
turn the regulator
to a lower number.
3. If your dishes are spotted
after washing,
turn the regulator
to a higher number.
OPTIDRY
TM
This feature senses when the unit is low on rinse
agent and automatically increases the drying
time.
15
Advertisement
Table of Contents
