Table of Contents
Advertisement
Operating the Dishwasher (continued)
Selecting
Dishwasher
Options
The factory default settings for all options should
provide
good results.
NOTE: The door must be open to activate
the
controls.
Options
Selections
You can access the available
options
in the
Options
Step Down Menu as follows:
Delay
Start
This option allows you to delay the start of the
selected
cycle for up to 24 hours in 30 minute
increments.
NOTE:In
the Options
Step Down Menu you can
return to the main menu at any time by pressing
the START button.
.
2.
3.
.
5.
.
7.
.
Open the dishwasher
door far enough to
expose the control panel.
Press the ON/OFF
button.
Press the MENU/OK
button once to display
the Delay Start option.
You must press the
button twice if you are out of rinse aid.
Press the + or - button until the display
shows
the desired
amount
of delay time.
After selecting
the desired
amount
of delay
time, you must press the MENU/OK
button
to save the setting. The display will indicate
"Value Stored" and return to the main menu.
If you did not select a delay time, press the
START button to return to the main menu.
Select the desired
wash cycle by pressing
the - or + buttons.
Close the door. When the time delay has
elapsed,
the dishwasher
will start
automatically
and continue
operating
through
the end of the selected
cycle.
You can change the time delay and/or the
wash cycle at any time during the delay.
POWERBOOST
TM
Reduces
the time to complete
the wash cycle by
preheating.
NOTE:
In the Options
Step Down Menu, you can
return to the main menu at any time by pressing
the START button.
1.
Open the dishwasher
door far enough to
expose the control
panel.
2.
Press the ON/OFF
button.
.
Press the MENU/OK
button twice to display
the POWERBOOST
TM
option.
You must
press the button three times if you are out of
rinse aid.
.
5.
This option can be turned
on or off by
pressing
the + button.
After selecting
the + button to turn on
POWERBOOST
TM,
you must press the
MENU/OK
button to save the setting. The
display will show "Value Stored" and return
to the main menu. If you did not select the +
button to change
the current setting,
press the START button to return to the
main menu.
6.
You can now select the desired
wash cycle
by pressing
the - or + buttons.
7.
Press START
and close the dishwasher
door to begin the cycle.
Control
Panel (Message
Display)
The dishwasher
will display
special
messages
to
give the user additional
information
about cycles.
This option allows you to turn this special
message
feature
on or off.
NOTE:
In the Options
Step Down Menu you can
return to the main menu at any time by pressing
the START button.
.
2.
3.
.
5.
Open the dishwasher
door far enough to
expose the control panel.
Press the ON/OFF
button.
Press the MENU/OK
button three times.
You
must press
the button four times if you are
out of rinse aid.
Press the + button to turn the Control
Panel
(Message
Display)
on or off.
After selecting
the desired
setting, you must
press the MENU/OK
button to save the
setting. The display will show "Value Stored"
and return to the main menu. If you did not
select
a different
setting,
press the START
button to return to the main menu.
Extra Drying
This option allows you to adjust the final rinse
temperature
to improve
drying or to save energy.
NOTE:
In the Options
Step Down Menu you can
return to the main menu at any time by pressing
the START button.
10
Advertisement
Table of Contents
