Table of Contents
Advertisement
10. Using a screw driver to remove
t h e s c r e w s a s s h o w n , a n d
remove the riser card.
11. Pull the optical drive carefully
and remove it as shown.
Follow the steps below to reinstall
the optical drive:
1. Place the optical drive in its place
as shown.
2. Using a screw driver fasten the
screws to secure the riser card
to the optical drive.
3. Secure the three screws that
secure the optical drive as
shown.
4. Connect the cables and put back
the front side of the front cover.
-
The IDE interface of this
system is specially designed,
please do notuse optical
d r i v e o f o t h e r b r a n d s .
Otherwise the optical drive
might be damaged due to
capatibility problem.
Chapter 2: Hardware setup
Advertisement
Table of Contents
