Table of Contents
Advertisement
6. Insert the transfer card with
the installed ZCR card into the
transfer card slot on the system
board.
7. Using two screws to secure the
card with the retainng poles on
the system board.
2.5.6 Configuring an expansion card
After installing the expansion card, configure it by adjusting the software
settings.
1. Turn on the system and change the necessary BIOS settings, if any. See
Chapter 5 for information on BIOS set up.
2. Assign an IRQ to the card. Refer to the following tables.
3. Install the software drivers for the expansion card.
-1
Chapter 2: Hardware setup
Advertisement
Table of Contents
