Ariens 911410-WAW 34 Owner's/Operator's Manual page 13

Lock P in
Spacers
Figure 7
Align t he open e nds o fthe spacers with the
flats o nthe caster spindle and remove the
spacers one atatime u ntil enough are left a t
the bottom f orthe desired cutting height.
Remove the lock p in while s upporting the
caster arm. Lower the arm ontop ofthe
remaining spacers. Put t he spacers that were
removed inthe caster spindle above the
support tube asshown (Figure 8).
Reinstall the lock p in into the top hole and flip
over the lock r ing tosecure the remaining
spacers and pin.
NOTE: Set b oth w heels atthe same h eight
foralevel cut.
Remove the
spacers from
the stack.
Secure spacers
above the
caster arm with
the lock p in.
NOTE: Axle positions are set a tthe
factory. There should benoneed t o
change the axle position inthe caster
innormal use ormaintenance.
Figure 8
GB -13