Re-Recording A Specific Section-Punch In/Out - Yamaha PSR-S950 Reference Manual

Re-Recording a Specific Section—Punch In/Out
When re-recording a specific section of an already-recorded Song, use the Punch IN/OUT function. In this
method, only the data between the Punch In point and the Punch Out point is overwritten with the newly
recorded data. Keep in mind that the notes before and after the Punch In/Out points are not recorded over,
although you will hear them play back normally to guide you in the Punch In/Out timing.
1
Select the desired Song for re-recording.
2
Call up the operation display.
[FUNCTION]  [F] DIGITAL REC MENU  [A] SONG CREATOR  TAB [E][F] REC MODE
3
Determine the settings for recording.
[1 ]–
REC START
[3 ]
(Punch In)
[4 ]–
REC END
[6 ]
(Punch Out)
Determines the Punch In timing.
NORMAL
Overwrite recording starts when the Song playback is started via the
SONG [F/ K]] (PLAY/PAUSE) button or when you play the keyboard in
the Synchro Standby mode.
FIRST KEY ON
The Song plays back normally, then starts overwrite recording as soon as
you play the keyboard.
PUNCH IN AT
The Song plays back normally up to the beginning of the indicated Punch
In measure, then starts overwrite recording at that point. You can set the
Punch In measure by pressing the [3 ] button.
Determines the Punch Out timing.
REPLACE ALL
This deletes all data after the point at which recording is stopped.
PUNCH OUT
The Song position at which recording is stopped is regarded as the Punch
Out point. This setting maintains all data after the point at which record-
ing is stopped.
PUNCH OUT AT
Actual overwrite recording continues until the beginning of the specified
Punch Out measure (set with the corresponding display button), at which
point recording stops and normal playback continues. This setting main-
tains all data after the point at which recording is stopped. You can set the
Punch Out measure by pressing the [6 ] buttons.
PSR-S950/S750 Reference Manual
3
59