Creating Original Sounds Via The Knobs; Selecting A Knob Effect Combination; Applying The Filter To The Main Voice - Yamaha PSR-I455 Owner's Manual

Creating Original Sounds via the Knobs

The two knobs located in the lower left area of the panel can be used to add variations
to the sound being played, transforming the sound in a variety of musical ways. Select
the desired pre-programmed effect combination printed above the Knobs, then rotate
the Knobs to enjoy the sound.
Selecting a Knob Effect Combi-
nation
Repeatedly press the [ASSIGN] button to sequentially
select the six effect combinations provided: (1)
    
(3) (4) (5) (6)
combination is shown in the display.
Harmnum1
001
(1)–(2) affect the entire the Tabla/Tanpura sound, (3)–
(5) affect the Main and Dual Voices only, and (6)
affects only playback of the Style and Tabla/Tanpura.
For details about each Knob effect, refer to page 37.
Only selecting a Knob effect combination will not
affect the sound even if the Knob arrow is not at
the initial position. After operating the Knob, the
selected effect is applied to the sound.

(2)
(1) ... etc. The current
001
Current value
Applying the Filter to the Main
Voice
1
Select the desired Main Voice.
Here, select "178 SquareLd" (Square-wave Lead)
as a synth-lead type Voice.
2
Press the [ASSIGN] button several times
until (3) (Filter) appears in the display).
3
Rotate Knob B all the way to the right
(maximum), then play the keyboard with
your right hand while operating Knob A
with your left.
Filter
Cutoff
NOTICE
• Selecting a different Voice will replace the settings
created via the Knobs with the default settings of the
new Voice. If you create a sound with the Knobs that
you wish to keep, make sure to memorize the settings
to Registration Memory (page 31) before selecting a
different Voice.
NOTE
• Rotating a Knob to the right while the volume is set to a
high level may result in distortion. If this occurs, reduce
the volume level.
Filter
Resonance
PSR-I455 Owner's Manual
21