Advertisement
Attaching
wand
and
tools
Attach any tool or wand to the hose by
pushing it firmly into hose.
Attach second wand or tool to wand by
pushing it firmly onto the wand.
Twist wand or tool slightly to tighten or
loosen the connection.
How
to clean
tools
To clean the hose, wipe off dirt with a
cloth dampened
in a mild detergent.
Rinse with a damp cloth.
Cleaning tools may be washed in warm
water with a detergent. Rinse and air dry
before using.
Disconnect cord from electrical outlet
before removing dirt container.
Under normal circumstances,
the only
maintenance your GUV
TM
vac requires is
emptying the dirt container as required,
and periodically
cleaning the filter.
To clean the dirt container:
1) Remove the dirt container by
unlatching
the latches located on each
side of the container.
2) Empty the dirt container into a trash
receptacle.
3) Replace dirt container, aligning
latches and latch holders, and secure
latches.
To clean the filter:
1) Remove the dirt container by
unlatching the latches located on each
side of the container.
2) Place a plastic grocery bag over the
main body that surrounds the filter.
3) Using the plastic bag as hand pro-
tection from dirt particles, shake the
filter to cause any particles adhering to
the filter to fall into the bag. (Fig. 4-2)
Discard bag.
4) Replace the dirt container and
secure latches.
\\4
In severe conditions, such as vacu-
uming drywall dust, etc., removing the
filter and properly cleaning will ensure
optimum performance
of your GUV
TM
vac.
5) To remove the cloth filter, grasp the
tab and pull towards the middle of the
unit.
gM
6) Take the filter to a trash receptacle
and shake to cause any particles adher-
ing to the filter to fall into the receptacle.
7) To replace the cloth filter, you must
decrease the circumference
of the filter
by pulling one side of the filter towards
the center of the filter to create a "V" or
"U" shape.
8) Place the filter back into the unit and
let the filter snap outward into the
groove.
IMPORTANT
Make sure the cloth filter is fitting
properly into the groove so it will not
come out when the machine
is turned
on. Failure to do so could void your
warranty.
Advertisement
