GE JGB920 Owner's Manual And Installation Instructions page 43

Read these instructionscompletely and carefully.
WARNING! A NTI- T IP DEVICE
All ranges can tip and injury could result.
Toprevent accidental tipping of the range, attach an approved Anti--tp device to the wall. (See Installing
the Anti--tp Device in this section.) Tocheck if the device is installed and engaged properly, carefully tip
the range forward. The Anti--tp device should engage and prevent the range from tipping over.
If you pu# the range out from the wall for any reason, make sure the Anti-tip device is engaged when
you push the range back againstthe wall.
For your
satety, never
use x_)ur range for
x_rming or beating
dae room. Your oven and
cooktop
are not designed to heat your kitchen. Top burners should not be operated without (:ookware
on the gTate. Such abuse (:ould result in fire and damage to your range and will void your
warTanty.
Do not store or use combnstible materials, gasoline or other flammable vapors and liquids in
the vicinity of this or any other appliance. Explosions or fires could resuh.
Do not use oven for a storage area. Items stored in dm oven can ignite.
Do not let (:ooking g_ease or other flammable materials accumulate in or near dm range.
LOCATION
Do not locate the range where it may be subject to strong drafts. Any openings in the floor or waft behind
the range should be sealed. Make sure the openings around the base of the range that supply fresh air
for combustion and ventilation are not obstructed by carpeting or woodwork.
Your range, like nrmly oilier household items,
is heaxT and can settle into soft floor coverings
such as cushioned vinyl or carpeting. Use care
when moving the range on this type of flooring.
It is recommended that the following simple
and inexpensive instructions be fbllox_d to
protect your floor.
Tire range should be installed on a sheet of
plDvood (or similar material). V_qmn tire floor
(:overing ends at tire fiont of the range, the area
that the rmNe will rest on should be built up
with pb_vood to the same level or higher than
the floor (:overing.
This will allow tire range to be re(wed for
deaning or servicing. Also, make sure your
floor coveringwill withstand 180°F. (See the
InstallationSafety Instructions section.)
Make sure tire x_ll coverings around }_)ur
range can witbsland tire heat generated (up to
200°F.) by tire range. (See the Installation Safety
Instructions section.)
IMPORTANT!
Remove aft tape and packaging. Make sure the burners are properly seated and level
Take the accessory pack out of the oven.
Check to be sure that no range parts have come loose during shipping.
43