GE JGB920 Owner's Manual And Installation Instructions page 39

Oven Shelves
Clean tile shelves _dth an abrasive cleanser
or steel wool. After cleaning, rinse tile
shelves xdth (lean water and chT with a
dean (loth.
NOTE: Takethe shelves out of the ovenbefore you
begin the self-clean cycle.
'
Wire cover holfle_
Oven Light Replacement
CAUTION: B eforereplacing yourovenlight bulb,
disconnect theelectrical p owerto therangeat the
mainfuseor circuitbreaker p anel.Besureto let the
hghtcover andbulbcoolcompletely
The oven light bulb is _overed with a
removable glass cover that is held in place
with a bail-shaped _dre. Remove the oven
door, if desired, to reach cover easily.
Toremove:
[] Hold a hand under the cover so it
doesn't fall when released. With fingers
of the same hand, firmly push back the
wire cover hoMer. IJfi offthe cover.
Do not remove any screws to remove the
cover.
[] Do not touch hot bulb xdth a wet ch)th.
Replace bulb with a 40-watt househoM
appliance bulb.
Toreplace cover:
[]
Place it into the gro¢_ve of the light
receptacle. Pull the wire fi)rward to the
center of the c¢)ver until it snaps into
place. When in place, the wire holds
the c¢)ver firmly. Be cert>fin the wire is
in the depression in the center of the
c()ver.
[] Connect electrical power to the range.
Fluorescent Top Light
CAUTION Donottouchthebulb with wet handsor
whenthebulbis hoL Neverwipethelightaraawith
a wet cloth.Electrlaal powermustbeshut off if you
havetoreplacethebulb.
[] Raise tile clips on the back, on 1)off1
sides, and fiee the ba(k ofthe (anopy.
[] Roll the canopyup and off.
[] Remove tile fluores(ent light bulb.
Replace the bulb with one of the same
length and wattage.
[]
Replace the canopy by pladng the
front in the groove and rolling it back.
Snap it into pla_e over the ba_k dips on
both sides.
39