Orienting The Module To The Mps-1 Chassis - Emotiva MPS-1 User Manual

Orienting the Module to the MPS-1 Chassis

Upon removing the EPM-300 power module from the packaging, you must orient which is the "top"
and "bottom" as well as which is the "front" and "back". The top has a single nylon rail while the bot-
tom has two nylon rails. It is important that the module be placed in so that the rails on the top and
bottom align with the corresponding "rail channels" in the MPS-1 chassis. The front of the module
that will be inserted into the chassis has an AC receptacle and a small printed circuit board while
the back of the module is where you will find the RCA/XLR connectors and speaker outputs.
Front
Single
Rail
(Top)
Dual
Rails
(Bottom)
Front
EPM-300 Power Module orientation
Before inserting the power module, confirm that the 115/230 VAC voltage setting is correct for the
country in which you are installing the MPS-1. These should be set correctly (by default) at the fac-
tory at the time of testing and packaging.
Back
Back
EPM-300 Power
Module bay
The back of the MPS-1 chassis looking "in" where the
EPM-300 module will be installed. (For clarity, the EPM-
300 modules are shown installed on either side of the
empty opening)
Single
Rail
(Top)
Dual Rails
(Bottom)
Page 16