EMI Corp Manual page 7

ELECTRICAL WIRING INSTALLATION SECTION
Note: Refer to the
units' wiring diagram
for all wiring.
8. Check wiring diagram for the re-
quired number of low voltage wires
to be run between indoor and out-
door sections.
Low Volt Connection
Completed
Electrical Connections
Multi-zone Heat Pump Condensing Units Multi-zone Heat Pump Condensing Units
Inside electrical
access panel.
Wire Diagram
9. Connect the 24 Volt wiring matching color
to color. Refer to the wiring diagram on the
inside panel of the condenser, and also
refer to the wiring diagram on the indoor
unit. Low Volt interconnect should be at
least 18 awg.
10. To replace side panel slide the slotted
holes of the panel onto the loosened
screws of the front
panel so that the panel so that the
edge of the front edge of the front
panel covers panel covers
the edge of the
side panel.
11. Fasten all remaining loose screws. 11. Fasten all remaining loose screws.
7 7
Low Volt
Plastic Edge Guards
www.enviromaster.com
High Volt