Installation Instructions - EMI Corp Manual

Side discharge unit allows for permanent
mounting through the feet. This is highly
recommended due to the vertical design
of the unit.
1. Loosen the screws on left and right sides
of the front panel. (Do not remove these
screws.)
2. Remove the screws on the front of the
panel.
3. To remove front panel:
4. Slide front panel forward to clear side
screws and remove.
Multi-zone Heat Pump Condensing Units

INSTALLATION INSTRUCTIONS

UNIT MOUNTING SECTION
Accumulator Compressor
Filter Driers
Lag Bolts
5. Insert lag bolts through the holes in
the bottom of the unit and tighten to
secure.
6. Insert lag bolts through the holes in the
feet on the back of the unit and tighten
to secure.
7. Replace the front panel, do not tighten
the side screws at this time.
5
Capacitor
www.enviromaster.com