Panasonic Workio DP-190 Operating Instructions Manual page 37

■ General Settings (For Key Operator) (Continued)
No.
Modes
11 ORIG. SET BEEP ADF
13 DEPT. COUNTER MODE
16 LANGUAGE PRIORITY
17 DATE & TIME
18 DAYLIGHT TIME
IP ADDRESS (DHCP) *
19
SUBNET MASK (DHCP) *
20
DEF. G/W IP (DHCP) *
21
DHCP DEFAULT *
22
DNS SERVER ADDR *
23
24 MAC ADDRESS
HARD DISK FORMAT *
25
HARD DISK ERR CHK *
26
27 ABBR GROUP ID
COMMUNITY NAME(1) *
28
COMMUNITY NAME(2) *
29
NOTE *
1
When setting other than DHCP server Network settings, Parameter No. "22 DHCP DEFAULT" should be set to "INVALID"
first, then setup Parameter No.19 to 21.
*
2
When Parameter No.19 to 23 (except 22) and No. 28, 29 are set, cycle the power by turning the Power Switch on the Left
Side of the machine OFF and ON.
*
3
Available only when the optional Hard Disk Drive Unit is installed.
*
4
When not connecting to LAN, the setting of DHCP should be on INVALID. When the setting of DHCP is on VALID,
and the machine is in Shutdown Mode, the machine will not answer an incoming Fax call.
Selects whether to enable the sound when
paper is placed on the ADF.
1:INVALID / 2:VALID
Monitors the copy usage of each department.
1: TOTAL COUNTER
2: DEPT. COUNTER
3: DEPARTMENT LIST
Selects whether to enable the language selection 1:OFF
menu to display when the machine comes out of
the Energy Saver Mode, or when the RESET
button is pressed once.
1:OFF / 2:ON
Sets the date and time.
Month, Day, Year, Time
Input the date and time using the Cursor Keys
and the Keypad.
Selects whether to enable the daylight time feature. 2:VALID
1:INVALID / 2:VALID
*
1, 2
Displays the address which was reserved by
DHCP server.
1, * 2
Displays the address which was reserved by
DHCP server.
*
1, 2
Displays the address which was reserved by
DHCP server.
4
Selects whether to enable the DHCP.
1:INVALID / 2:VALID
2
Selects whether to enable the DNS Server, and 2:VALID
sets its settings for Internet Fax/Email Function.
1:INVALID
2:VALID
<Sub Function>
1:HOST NAME / 2:DOMAIN NAME /
3:PRI. DNS SERVER (IP ADDRESS1) /
4:SEC. DNS SERVER (IP ADDRESS2)
Indicates the MAC address.
3
Formats the hard disk.
3
Selects the provision for the hard disk error check.
Inputs the group ID for the address book.
0-99
2
Selects whether to change the Community
Name(1) SNMP.
Enables read only.
2
Selects whether to change the Community
Name(2) SNMP.
Enables read/write.
Function
Initial
Setting
2:VALID
Consult your
authorized
service provider
2:VALID
0
public
public
37