Problem Solving - Panasonic Workio DP-190 Operating Instructions Manual

3
LTR ->LTR [LTR
ZOOM:100% COPIES:001
Select desired settings
(See pages 24-33)
■ Copying onto Transparency Film (OHP), Thick Paper Stock, etc. (except thin paper)
Before Pressing Start Key
Rear Cover
For Tray-1
Load Paper: Face Down
Paper Weight: 16 - 28 lb
(2-Sided Copy:
20 - 24 lb)
Paper Capacity: 250 Sheets (20 lb)
For Tray-2
Load Paper: Face Down
Paper Weight: 16 - 28 lb
(2-Sided Copy:
20 - 24 lb)
Paper Capacity: 550 Sheets (20 lb)
NOTE:
1) When changing the paper size, refer to page 42.
2) Feeding paper into the Sheet Bypass at the same
time when the copying/printing has started and
paper is feeding from either Tray 1 or Tray 2, will
show "REMOVE MISFED PAPER J00" message
on the LCD display. When this occurs, remove the
paper from the Sheet Bypass to reset the jam
indication then resume copying/printing.
3) Do not leave a paper in the Sheet Bypass as paper
jam indication may display.
4
Reduction/
Enlargement only
1] LTR ->INV
ZOOM: 65% COPIES:001
Making Copies
Catch
3
3
5
[LTR 1]
Number of
Copies
(Max. 999)
1
Open Rear Cover.
2
Catch the ejected copy (do not pull).
3
When finished, close the Rear Cover.
NOTE:
Do not open the Rear Cover when copying
thin paper as it may cause a paper jam.
Firmly close the Paper Tray.
NOTE:
1) To prevent paper jams or other problems,
Paper Tray-1
adjust the paper guides (Length & Width)
when loading paper into the tray.
2) When changing the paper size, refer to
page 42.
3) Make sure that the paper is set properly
and that it does not exceed the Tray-1/
Tray-2 Max. Level indicator.
4) When replenishing paper into Tray-2,
please see page 21.
Paper Tray-2

■ Problem Solving

Adding Paper
Replacing Toner Cartridge
Removing a Misfed Paper
U## (User Error Code)
J## (Jam Error Code)
E## (Machine Error Code) (Call your Service Provider)
Maximum Copies Limitation
(See pages 14 and 21)
(See page 16)
(See page 18)
(See page 20)
(See page 20)
(See page 13)
15