Boot Device Priority; Boot Settings Configuration; Security - Asus P5QL-EM - Motherboard - Micro ATX User Manual

2.6.1. Boot.Device.Priority
1st.~.xxth.Boot.Device.[1st.Floppy.Drive]
These items specify the boot device priority sequence from the available devices. The
number of device items that appears on the screen depends on the number of devices
installed in the system. Configuration options: [xxxxx Drive] [Disabled]
2.6.2

Boot Settings Configuration

Quick.Boot.[Enabled]
Enabling this item allows the BIOS to skip some power on self tests (POST) while booting to
decrease the time needed to boot the system. When set to [Disabled], BIOS performs all the
POST items.
Configuration options: [Disabled] [Enabled]
Full.Screen.Logo.[Enabled]
This allows you to enable or disable the full screen logo display feature. Configuration
options: [Disabled] [Enabled]
Set this item to [Enabled] to use the ASUS MyLogo2™ feature.
Add.On.ROM.Display.Mode.[Force.BIOS]
Sets the display mode for option ROM. Configuration options: [Force BIOS]
[Keep Current]
Bootup.Num-Lock.[On]
Allows you to select the power-on state for the NumLock.
Configuration options: [Off] [On]
Wait.for.'F1'.If.Error.[Enabled]
When set to Enabled, the system waits for the F1 key to be pressed when error occurs.
Configuration options: [Disabled] [Enabled]
Hit.'DEL'.Message.Display.[Enabled]
When set to Enabled, the system displays the message "Press.DEL.to.run.Setup" during
POST. Configuration options: [Disabled] [Enabled]
2.6.3.

Security

The Security menu items allow you to change the system security settings. Select an item
then press <Enter> to display the configuration options.
Change.Supervisor.Password
Select this item to set or change the supervisor password. The Supervisor Password item on
top of the screen shows the default Not Installed. After you set a password, this item shows
Installed.
2-20 Chapter 2: BIOS setup