Gigabyte GA-890FXA-UD7 User Manual page 82

B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test).
Make sure OnChip SATA Controller is enabled. To enable RAID for the SATA3_0/1/2/3 connectors, set On-
Chip SATA Type to RAID. To enable RAID for the SATA3_4/5 connectors, set OnChip SATA Type to RAID
and set OnChip SATA Port4/5 Type to As SATA Type (Figure 1). To enable support for RAID 5, set OnChip
SATA RAID5 Support to Enabled.
OnChip SATA Controller
OnChip SATA Type
OnChip SATA Port4/5 Type
OnChip SATA RAID5 Support
OnChip SATA3.0 Support
 Onboard PCIE Devices
Onboard Audio Function
Onboard 1394 Function
Onboard USB 3.0 Controller
USB Controllers
USB Legacy Function
USB Storage Function
Onboard Serial Port 1
Onboard Parallel Port
Parallel Port Mode
x ECP Mode Use DMA
higf : Move Enter: Select
F5: Previous Values
Step 2:
Save changes and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your moth-
erboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you
have and the BIOS version.
Appendix
CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
Integrated Peripherals
+/-/PU/PD: Value
F6: Fail-Safe Defaults
[Enabled]
[RAID]
[As SATA Type]
[Enabled]
[Enabled]
[Press Enter]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[3F8/IRQ4]
[378/IRQ7]
[SPP]
3
F10: Save
Figure 1
- 82 -
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults