Gigabyte GA-890FXA-UD7 User Manual page 52

Onboard PCIE Devices
Primary Dual Slot Config
Secondary Dual Slot Config
PCIEX4_2 Slot Config
Onboard GSATA controller
Onboard GSATA Mode
Onboard ESATA controller
Onboard ESATA Mode
Onboard LAN1 Function
Onboard LAN1 Boot ROM
 SMART LAN1
Onboard LAN2 Function
Onboard LAN2 Boot ROM
 SMART LAN2
higf : Move Enter: Select
F5: Previous Values
Primary Dual Slot Config (PCIEX16_1 and PCIEX8_1 slots)
Specifies the operating bandwidth for the PCIEX16_1 and PCIEX8_1 slots.
Auto
X16
X8/X8
Secondary Dual Slot Config (PCIEX16_2 and PCIEX8_2 slots)
Specifies the operating bandwidth for the PCIEX16_2 and PCIEX8_2 slots.
Auto
X16
X8/X8
PCIEX4_2 Slot Config
Specifies the operating bandwidth for the PCIEX4_2 slot.
As X1 Link
As X4 Link
Onboard GSATA controller (GIGABYTE SATA2 Chip, IDE and GSATA2_6/7 Connectors)
Enables or disables the IDE and SATA controllers integrated in the GIGABYTE SATA2 chip. (Default:
Enabled)
Onboard GSATA Mode (GIGABYTE SATA2 Chip, GSATA2_6/7 Connectors)
Enables or disables RAID for the SATA controller integrated in the GIGABYTE SATA2 chip or configures
the SATA controller to AHCI mode.
IDE
AHCI
RAID/IDE
BIOS Setup
CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
Onboard PCIE Devices
+/-/PU/PD: Value
F6: Fail-Safe Defaults
Lets the BIOS automatically configure this setting depending on the device being
installed. (Default)
PCIEX16_1 operates at x16 and PCIEX8_1 becomes unavailable.
PCIEX16_1 and PCIEX8_1 operate at x8 respectively.
Lets the BIOS automatically configure this setting depending on the device being
installed. (Default)
PCIEX16_2 operates at x16 and PCIEX8_2 becomes unavailable.
PCIEX16_2 and PCIEX8_2 operate at x8 respectively.
PCIEX4_2 operates at x1 mode. (Default)
PCIEX4_2 operates at x4 mode. Please note that due to bandwidth sharing, the
onboard IDE, GSATA2_6, and GSATA2_7 connectors will become unavailable.
Configures the SATA controller to IDE mode. (Default)
Configures the SATA controller to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specification that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug.
Enables RAID for the SATA controller; the IDE controller still operates in IDE mode.
[Auto]
[Auto]
[As X1 Link]
[Enabled]
[IDE]
[Enabled]
[IDE]
[Enabled]
[Disabled]
[Press Enter]
[Enabled]
[Disabled]
[Press Enter]
F10: Save
- 52 -
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults