Chassis Intrusion Connector - Asus P5LD2-X GBL User Manual

7. CPU and chassis fan connectors (4-pin CPU_FAN, 3-pin CHA_FAN)
The fan connectors support cooling fans of 350 mA ~ 2000 mA (24 W max.) or
a total of 1 A ~ 3.48 A (41.76 W max.) at +12V. Connect the fan cables to the
fan connectors on the motherboard, making sure that the black wire of each
cable matches the ground pin of the connector.
Do not forget to connect the fan cables to the fan connectors. Insufficient air flow
inside the system may damage the motherboard components. These are not
jumpers! Do not place jumper caps on the fan connectors!
P5LD2-X/GBL
P5LD2-X/GBL Fan Connectors
Only the CPU_FAN connector support the ASUS Q-Fan feature.
8. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default, the pins labeled "Chassis Signal" and "GND" are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
P5LD2-X/GBL
P5LD2-X/GBL Intrusion Connector
2-28
CPU_FAN CHA_FAN
GND
CPU FAN PWR
CPU FAN IN
CPU FAN PWM
CHASSIS
(Default)
Chapter 2: Hardware information
GND
+12V
Rotation